Recently, we have received a lot of inquiries from users of our wire stripping machine in various ways.Today, we have sorted out the most concerned about users. Questions, give a comprehensive answer, and provide you with the troubleshooting method of the automatic wire stripping machine.

Q: What should I do if the wire core is cut off during stripping?
A: 1. Increase the value of the wire diameter until it reaches a suitable level (the best position is when the blade has just cut through the wire sheath but cannot damage the wire core). If the wire sheath is very thin, after adjusting the wire diameter, it is found that it cannot be peeled off, so it can be appropriately reduced Retract value.

Q: What should I do if the thread skin is always crushed?
A: Adjust the gap between the incoming wire transmission wheel and the outgoing wire transmission wheel. If the transmission wheel is damaged, please replace the transmission wheel.

Q: The length of the stripped wire is different, the actual wire length is greater than or equal to the set wire length
A: Adjust the "Incoming Line Clearance Adjustment Wheel" to increase the pressure. If the gap between the incoming wire transmission wheel is too large, sometimes the wire ends cannot be stripped, and there is dirt in the incoming wire pipe, please check and clean it properly.

Q: The length of the wire is different, the actual stripping length is less than or equal to the set wire length
A: The wires themselves have different thicknesses. The scroll wheel is dirty and needs to be cleaned. There is wax on the wire surface, causing slippage of the incoming and outgoing wire transfer wheels. Take out the line, set the program to "00", run dry, stop, and check whether the rotation of the "in and out pulley" is flexible or stuck. The pay-off frame is stuck, causing the input line to slip.

Q: Why can't the wire ends be stripped during stripping?
A: Check the set cutting depth and adjust the small wire diameter value. The gap of the incoming wire transmission wheel is too large, adjust the gap of the incoming wire transmission wheel. Whether the stripping head setting is greater than 2mm. Clean the inlet pipe, the setting of the retract tool is too large and needs to be reduced.

Q: When stripping the wire, the end of the wire cannot be stripped
A: Check the set cutting depth and adjust the wire diameter to decrease. The gap of the incoming wire transmission wheel is too large, adjust the gap of the incoming wire transmission wheel. Whether the stripping head setting is greater than 2mm. The retract setting is too large and needs to be reduced.

Q: What should I do if some of the cores are too long?
Answer: The wire diameter of the wire itself is too small. When stripping the wire, the blade cuts to the wire core. It is necessary to increase the wire diameter value and the retraction setting is too small. The retraction parameter should be appropriately increased. Add oil to the part and try again (usually once every 2 hours of operation), slow down the speed and try again. Check whether the wire size is within the allowable range of this model. The blade is damaged or dull.

Q: The stripped wire incision is inclined
A: The wire itself is too curved and needs to be straightened. The wire edge is not aligned with the center of the knife edge, and then try again after clearing the alignment.

The above are the most common fault handling methods for automatic wire stripping machines. It is recommended to choose wire stripping machines with high performance and quality to reduce the possibility of failures. If you encounter any faults that cannot be handled, you are welcome to consult us.